hayeslewis
New member
I acquired this all for a vintage project prior to COVID. Unfortunately circumstances have changed and I'm looking to let it go. Most of the motor bits and clutch came from Craig Chima. The shell came out of Georgia.
Best to contact me via txt at svn-oh-tree too-sex-nin svn-tree-fv-svn
Make sure you lead your text with "Spridget Part interest"
Possible trade interest-unlikely, but I'm always willing to listen!
Wiling to part out with a good offer.
$9K OBO
1275 thick rail stock bore block-Had virgin bores. I had it properly bored .040 over with a torque plate by an excellent shop that
Bored with a torque plate to .040 over
4 bolt billet center main cap kit
1275 high volume oil pump
Huffaker rear seal kit with new seal
Double row vernier (adjustable) cam timing gear set
ARP head and rocker stud kits
Titan High lift roller rockers
Stock set 1275 pushrods (as we talked about, I used stock pushrods on my motors for years)
Aluminum backplate
Moldex billet crank
George Bauchman fully prep race head
Carillo long rod-6"-set with new CP .035 pistons and rings and buttons (pistons
already fitted for 1275 block height)
Tilton Clutch
All that came from Craig.
I purchased the following separately
296 Scatter Pattern Camshaft, Vintage Race, New Blank (SPVP4-BK)
Straight cut race gear set from Peter May
1972 (round arch) MG Midget fully Caged roller. Has a cell, though it will need new foam. Stock suspension.
Best to contact me via txt at svn-oh-tree too-sex-nin svn-tree-fv-svn
Make sure you lead your text with "Spridget Part interest"
Possible trade interest-unlikely, but I'm always willing to listen!
Wiling to part out with a good offer.
$9K OBO
1275 thick rail stock bore block-Had virgin bores. I had it properly bored .040 over with a torque plate by an excellent shop that
Bored with a torque plate to .040 over
4 bolt billet center main cap kit
1275 high volume oil pump
Huffaker rear seal kit with new seal
Double row vernier (adjustable) cam timing gear set
ARP head and rocker stud kits
Titan High lift roller rockers
Stock set 1275 pushrods (as we talked about, I used stock pushrods on my motors for years)
Aluminum backplate
Moldex billet crank
George Bauchman fully prep race head
Carillo long rod-6"-set with new CP .035 pistons and rings and buttons (pistons
already fitted for 1275 block height)
Tilton Clutch
All that came from Craig.
I purchased the following separately
296 Scatter Pattern Camshaft, Vintage Race, New Blank (SPVP4-BK)
Straight cut race gear set from Peter May
1972 (round arch) MG Midget fully Caged roller. Has a cell, though it will need new foam. Stock suspension.