prodracing.com
http://prodracing.com/

Schroeder bar
http://prodracing.com/viewtopic.php?f=7&t=18869
Page 1 of 2

Author:  jacko241 [ Wed Dec 12, 2018 9:44 am ]
Post subject:  Schroeder bar

Is anyone using a Schroeder type sway bar? The car I bought has one, but the installation was never completed.

Author:  zChris [ Thu Dec 13, 2018 5:07 am ]
Post subject:  Re: Schroeder bar

Yes, in the rear of my GT3 car. What do you want to know. They are popular in Nascar and can be found on ebay used.

Author:  jacko241 [ Thu Dec 13, 2018 3:11 pm ]
Post subject:  Re: Schroeder bar

Would you know who would be a good source for bars and arms?

Author:  carshouston [ Thu Dec 13, 2018 3:38 pm ]
Post subject:  Re: Schroeder bar

Schroeder was bought by PAC Racing

https://www.racingsprings.com/

Author:  Rick Starkweather [ Thu Dec 13, 2018 8:48 pm ]
Post subject:  Re: Schroeder bar

Joe:

I have some torsion bars and fabricated arms (front and rear) for an MGB that I bought from Todd Bunger who used to race a very competitive MGB in the SCCA. What are you looking for?

Rick

Author:  jacko241 [ Fri Dec 14, 2018 4:49 am ]
Post subject:  Re: Schroeder bar

Rick, I sent you a PM.

Author:  Jay Lutz [ Fri Feb 01, 2019 9:02 am ]
Post subject:  Re: Schroeder bar

Schroeder is a good source for spline type swaybars front and rear...……...also steel or aluminum arms. The only negative is you need to be able to select and then calculate the WHEEL rate it creates. This means you must know the bar and control arm motion ratios to do this calculation. I think you can get them timed or not timed.

The biggest advantage is that you can just order off the shelf bars for testing and have them in a couple of days. Make sure they offer hollow bars for the front with varying wall thicknesses. Super cheap way to get the car balance exactly right...…….not kinda right.

Author:  jacko241 [ Sun Feb 03, 2019 8:56 am ]
Post subject:  Re: Schroeder bar

Thanks, Jay. The bar that came in this car is a solid 1 1/16, so I knew it was way too heavy.

Author:  Protech Racing [ Sun Feb 03, 2019 10:01 am ]
Post subject:  Re: Schroeder bar

Depends on the arm length.

Author:  Jay Lutz [ Mon Feb 11, 2019 2:12 pm ]
Post subject:  Re: Schroeder bar

ogren is correct. pick an arm length that packages and adjust bar diameter and/or wall thickness to tune.

Page 1 of 2 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/